Minec 4x Instrukcja Użytkownika Pobierz pdf (Strona 11)

2. Exchangeable Modules

An exchangeable module is fitted at the top of the Minec 4x behind the

display. This module can contain different accessories to make your work

with the Minec 4x easier. On delivery the hand-held is fitted with the module

that has been ordered. Should your requirements change, the Minec 4x

terminal can be sent in and the existing module can be replaced by another.

A switch to another module usually requires changes to the application

program as well.

Note ! Do not try to dissemble the Minec 4x yourself. The encapsulation

level may not be maintained if the hand-held is taken apart by others than

qualified service personnel.

Most of the modules are described below. However, new modules are being

developed all the time and there are separate manuals for the latest

additions.

RS232 module

This module has a 6-pin Hirose port for connection

via a special cable to a PC or printer.

Communication is controlled by the application

program in the Minec 4x. Signal levels in the

port meets the standard RS232 protocol.

Laser module

This module has a built-in laser scanner that makes it

possible to read barcodes from a distance (the actual

distance depends on factors such as the size of the

barcode).

The application program controls the way this module

is used. The laser is usually activated by pressing the

SCAN key. The laser remains on until an approved

code has been read by the Minec 4x or until a pre-

programmed time (usually 5 seconds) has passed.

Minec 4x User Handbook

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Brak uwag

Minec 4x Instrukcja Użytkownika Strona 11